Baluster spacing

Enter the clear opening between posts, the baluster width and the largest gap allowed. Get three ways to lay it out, pick one, and take the mark list to the rail.

Openings
Clear distance between post faces. Enter inches as 72 3/8, 72.375 or 6' 0 3/8. Add more openings to match spacing across sections.
Balusters Use the narrowest width. On turned balusters the gap is measured at the thinnest part, not the square block.
Gaps in the layouts never exceed this. If you want a margin, enter 3 7/8 or 3 15/16.
Layout
Used by the two "round" layouts. Marks are always given to the nearest 1/16.
Forces an odd or even count so a baluster or a gap lands on the centerline. Fewest just uses the minimum count.
Uncommon. Use when the end baluster butts the post with no gap, as in some panel builds and metal kits.
How the layouts differ
  • Round and centered. One spacer block for every interior gap, rounded to 1/8 or 1/4. Whatever is left over splits evenly into the two end gaps, so the pattern is symmetric. The end gaps are close to the interior gap but usually not identical. Mark the first baluster from one post, then step off with the block.
  • Round, remainder at far end. Same round gap from the near post, walked off with the block. The leftover is spread as a few gaps one increment larger, grouped at the far post where the eye does not catch them. Only the last gap, against the far post, is off the increment and you never have to mark it.
  • Exact equal. Every gap identical to the fraction. Marks are rounded to the nearest 1/16 and each mark is a running measurement from the post, so a spacer block error cannot build up. Use a tape, not a block.
  • Several openings. When you enter more than one opening, the match card finds one interior gap that works in every section so adjacent panels read the same. Each section's end gaps take up the difference.