Barn doors: double, hinged

A pair of framed, braced doors hung on strap hinges in one opening. Enter the rough opening and pick the options to get door sizes, hinge sizes and placement, drawings, a cut list and a shopping list.

Opening
Framing to framing. Height is from the floor or sill up to the underside of the header. Accepts 72 1/2, 72.5 or 6' 1/2. Boards lining the sides and top of the opening. Enter 0 if the doors hang right in the framed opening.
Clearances
Room for paint and seasonal swelling. Raise the bottom clearance if the doors have to clear a lip, gravel or a sloped sill.
Frame
Face boards Coverage is the width each board adds once the joint is together. It varies by mill, so check yours and use Custom if it differs.
Hardware and extras
Finish
Buying lumber
Auto tries each common length for each kind of lumber and keeps the one that needs the least total length. Trim is the total cut off bad ends per board.

How to use it

  1. Measure the rough opening at the top, middle and bottom for width, and at both sides for height. Enter the smallest of each.
  2. Enter the jamb board thickness, or 0 if there are no jamb boards. Adjust the clearances if needed.
  3. Leave the frame on Auto, or pick A or C yourself.
  4. Tick the hardware and finish you want on the shopping list.
  5. Use the drawings, hinge section, cut list and shopping list. Print the plan for the shop.

Building order

  1. Cut the stiles and rails and screw each frame together square (2x4 frame) or lay the pieces out square on the boards (1x6 frame).
  2. Measure each frame bay corner to corner and compare it with the brace's tip-to-tip check length. Cut the braces to fit tight into the corners.
  3. Prime all faces, edges and end grain before assembly if you can. Bare wood hidden behind the frame never gets painted later.
  4. Lay the boards face down, set the frame on them, and screw through the frame into the boards: two screws per board at each rail and brace, near the middle of the board so it can swell and shrink.
  5. Mark the hinge centerlines from the hinge section, set the straps on the outside face, and drill straight through for the carriage bolts.
  6. Hang the hinge-side leaves with shims under them at the bottom clearance, then fit the astragal, bolts, latch and pulls.
Which way the brace runs, and why

On each door the brace runs from the bottom corner on the hinge side up to the top corner on the meeting side. The weight of the free edge then pushes down along the brace into the bottom hinge, so the brace works in compression. Run the other way, the brace would rely on its screws to hold the door up and the door would sag. The two doors are mirror images, so their braces form an upside-down V.

What a drip cap does

A drip cap is a narrow metal flashing, Z-shaped in profile, installed over the top of the opening. Its upper leg tucks behind the barn boards above the opening, and its lower lip sticks out past the face of the doors. Rain running down the wall is carried out past the door tops instead of soaking into their end grain or running into the shed through the top gap. Slip the top edge up behind the boards rather than face-nailing through the bend, so water can't follow the nails in.

Cutting the brace

The brace ends are cut parallel to each other (a parallelogram), both at the same saw setting. Cut one end, measure the edge length along either long edge from the pointed corner of that cut, then make the second cut leaning the same way. Since the brace is laid flat, the same piece works for the other door by flipping it over. If the setting is past your miter saw's range, clamp a square block to the fence and hold the brace against it so it runs straight out from the fence; the saw then cuts 90° minus its setting.