Shelf bracket cut list

Three-piece wooden bracket: a horizontal leg lying flat under the shelf, a vertical leg lying flat against the wall, and a diagonal brace on edge between them. Enter the shelf depth and stock to get the cuts.

Shelf Front to back. Accepts 11 1/4, 11.25 or 1' 2 1/2. The horizontal leg stops this far short of the shelf front.
Stock Legs lie flat, so their thickness shows in profile. The brace stands on edge, so its width shows in profile and sets the angled cuts.
Brace
Angle of the brace from the horizontal leg.
Measured to the tip (long point) of the brace, which is what you see and mark.
Buying stock
Trim is the total cut off bad ends per board.

How to use it

  1. Enter the shelf depth. The horizontal leg is cut to the depth minus the overhang, so the shelf hides the bracket end.
  2. Pick the stock for the legs and for the brace. They can differ. The legs lie flat (wide face to the shelf and to the wall); the brace stands on edge for strength.
  3. Pick 45° for a classic look, or 30° when the bracket should not reach as far down the wall.
  4. Cut the two legs square. Cut the brace with the two angles shown, measuring tip to tip along the long edge.
  5. Assemble: vertical leg flat against the wall, horizontal leg flat on top of it, brace on edge and centered across the legs' width, tips landing at the exposed distances shown.
Cutting a 60° end on a miter saw

The top end of a 30° brace is cut 60° off square, past the range of most miter saws. Set the saw to 30° instead, clamp a square block or scrap against the fence, and hold the brace against that block so it runs straight out from the fence (perpendicular to it). The 30° setting now produces the 60° cut. A table saw with the miter gauge set to 30° does the same job.