Shed framing design

Jump to the design ↓

Size the foundation, floor, walls and roof of a small shed from its dimensions and the snow and wind for its location. Choose how heavily each room will be loaded, and the tool designs every member, checks bracing and hold-down, and builds the cut list and shopping list.

1. Size and rooms
Outside of framing, front to back. Rafters span this way.
Top of floor to top of the double top plate. 8' 1 1/8" uses 92 5/8" precut studs.
Partitions are sheathed on one side with the wall panels so they brace the shed.
2. Roof
Measured level from the wall. Eaves are the low edges, rakes are the sloped gable or end edges.
For solar panels or anything else on the roof.
3. Site (from the ASCE Hazard Tool)
How to look these up
  1. Open ascehazardtool.org and enter the address or click the site on the map.
  2. Pick the standard ASCE/SEI 7-22 and the risk category below (I or II).
  3. Tick Snow and Wind and view the results.
  4. Enter Ground Snow Load, pg. Don't use the line marked "IRC only, pg(asd)"; this tool converts to ASD itself.
  5. Enter the basic wind speed V. Also note the elevation for the box below.
Risk category I covers buildings whose failure is a low risk to people, such as minor storage. Look up the snow and wind for the category you pick. Exposure: use C unless woods or buildings surround the site for a good distance in every direction.
Sheltered means tight among conifers, which keeps snow from blowing off. Kzt stays 1.0 unless the shed sits on an exposed hilltop, ridge or escarpment.
Elevation slightly lowers wind pressure (leave blank to skip). Frost depth is set by your town; it's used only for piers. Presumed bearing values from IRC Table R401.4.1.
4. Roof snow
5. Framing and sheathing
Check the grade stamp. Treated lumber is used for the floor framing and skids or beams, which sit close to the ground.
The panels brace the walls. Closer edge nailing makes them stronger.
6. Foundation
Frost-depth footings aren't required for light-frame accessory buildings up to 600 sq ft with eaves 10 ft or lower (IRC R403.1.4.1).
7. Extras and buying

How to use it

  1. Enter the width, wall height and rooms. For each room, set its length, how heavily it will be loaded, and what each wall has: solid, a door, windows, or a knee wall with awnings.
  2. Set the roof shape, pitch and overhangs.
  3. Look up the ground snow load and wind speed for the site (step 3 explains how) and enter them. The design appears once both are in.
  4. Keep the code snow load, or enter your own maximum if you will clear the roof.
  5. Pick the lumber, sheathing and foundation, or keep the defaults.
  6. Read the design cards and the checks. Anything over 100% or marked as failing tells you what to change. Then use the drawings, cut list and shopping list, and print the plan.
What the percentages mean

Each check divides what the member has to carry by what it can carry under the code (ASD). 100% is the limit. The tool picks the smallest common size that stays at or under 100%, so most members land somewhere between 40% and 100%.